devn-dm9102.so

Driver for Davicom DM9102 Ethernet controllers

Syntax:

io-net -d dm9102 [option[,option ...]] ... &

Options:

Use commas (,) to separate the options (not spaces). These options will override auto-detected defaults.

did=0xXXXX

Device ID.

duplex=0|1

Half (0) or full (1) duplex mode. The default is automatically detected on supported hardware. If you specify duplex, specify speed as well; if duplex alone is specified, it is ignored and both speed and duplex are auto-negotiated.

mac=XXXXXXXXXXXX

MAC address of controller. If no SROM is available, the MAC will default to 00:00:00:00:00:00

nomulticast

Disables multicast support.

pci=0xXXXX

PCI index of the controller.

phyaddr=num

Override the mii routines and use the specified phy address.

pktque=num

Limit the number of packets in the queue. The default is 100.

priority

Priority of the driver thread. The default is 21.

promiscuous

Enable promiscuous mode.

receive=num

Set the number of receive descriptors. The default is 64.

single

Configure and run only the first DM9102 card that is found (single instance).

speed=10|100

Media data rate (10Mbit or 100Mbit operation). The default is automatically detected on supported hardware. If you specify speed, specify duplex as well; if speed alone is specified, the specified speed will be correctly set, but duplex will default to half (0).

threshhold=N

The amount of packet data that must be in TX FIFO before transmission is initiated. The range is 0-4. The default is 3.

transmit=num

Set the number of transmit descriptors. The default is 128.

verbose

Be verbose.

vid=0xXXXX

PCI vendor ID.

Description:

The devn-dm9102 driver controls Davicom DM9102 Ethernet controllers.

Examples:

Start io-net using the dm9102 driver and the full TCP/IP stack:

io-net -d dm9102 -p tcpip
ifconfig en0 10.0.0.184

See also:

io-net

"Network drivers (devn-*)" and "Network protocol interfaces (npm-*)" in the Utilities Summary