View topic - Create partition FAT in NAND
Create partition FAT in NAND
21 posts
• Page 2 of 2 • 1, 2
Re: Create partition FAT in NAND
Right. But you must have the devil-may driver for this, right? I tried to devf-generic but without success.
I can "mount" ETFS without this devf-? My case is a NAND Micron.
I can "mount" ETFS without this devf-? My case is a NAND Micron.
- cleitonbueno
- Active Member
- Posts: 34
- Joined: Thu Mar 10, 2016 1:21 pm
Re: Create partition FAT in NAND
Usually, the devf driver sources needed for your board are in the BSP in src/hardware/flash.
- nico04
- Senior Member
- Posts: 171
- Joined: Wed Sep 29, 2010 9:59 am
- Location: France
Re: Create partition FAT in NAND
Yes. But I'm using BSP I downloaded the QNX website does not. I will try to see some other than use this Micron memory.
- cleitonbueno
- Active Member
- Posts: 34
- Joined: Thu Mar 10, 2016 1:21 pm
Re: Create partition FAT in NAND
Some example for dvd- driver for Micron Flash?
The BeagleBoard-xm uses Flash Micron, but devf- generates the error 'Bus Error' I have no knowledge with drivers for QNX.
The BeagleBoard-xm uses Flash Micron, but devf- generates the error 'Bus Error' I have no knowledge with drivers for QNX.
- cleitonbueno
- Active Member
- Posts: 34
- Joined: Thu Mar 10, 2016 1:21 pm
Re: Create partition FAT in NAND
Have a look here : http://community.qnx.com/sf/wiki/do/vie ... mapL138Evm
- nico04
- Senior Member
- Posts: 171
- Joined: Wed Sep 29, 2010 9:59 am
- Location: France
Re: Create partition FAT in NAND
Thanks, I will download, check the flash and etfs in BSP, I go compile and test. Soon answer.
- cleitonbueno
- Active Member
- Posts: 34
- Joined: Thu Mar 10, 2016 1:21 pm
21 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 0 guests