View topic - QNX6.5 smp installation problem

QNX6.5 smp installation problem

QNX Application portings.

QNX6.5 smp installation problem

Postby rsreddy » Mon Nov 05, 2012 12:38 pm

Hi ,

I installed qnx6.5.0 through DVD on kontron cp3002 with Intel® Core™ i7 processor, after installation completes, when booting its showing errors.

ahci SIM attach failure

Shutdown[0,0] S/C/F=11/1/11 C/D=f001517d/f00571ac state(c0)= now lock exit

..i think kernel dump.

however its booting well when i select qnxbase.ifs not in smp mode ...but taking more time to detect hardware like keyboard ,mouse.

can any give me solution pls.
Active Member
Posts: 16
Joined: Tue Jun 07, 2011 5:38 am

Re: QNX6.5 smp installation problem

Postby maschoen » Mon Nov 05, 2012 2:11 pm

I can understand your frustration in not getting an answer the first time you posted this question.

I think that the reason you did not get an answer is that no one here knows the answer. As I understand things, the AHCI has something to do with SATA, which means a disk driver. If your setup does not have a SATA drive you could try creating the .boot file with out the SATA driver. Otherwise you probably need to talk with QNX about this. If a driver works with the non-smp kernel and but doesn't work with the smp kernel, it suggests a serious race condition problem in the driver. If this is the case, I'm sure QNX will have a concern as well as you.

I did run into a similar problem a while back. The Adaptec SCSI driver I was using under QNX 6.2 caused a kernel crash on the server I was running with the SMP kernel. The eventual upgrade to 6.3 vanquished the problem.

One last thought, I just read that apparently AHCI can usually be turned off in the BIOS. The context for this posting at was that with WIndows 7, you want to turn AHCI before you install as turning it on afterwards can cause problems.
QNX Master
Posts: 2730
Joined: Wed Jun 25, 2003 5:18 pm

Return to Porting

Who is online

Users browsing this forum: No registered users and 1 guest