View topic - PCI express to SCSI/SATA2 driver
PCI express to SCSI/SATA2 driver
2 posts
• Page 1 of 1
PCI express to SCSI/SATA2 driver
Hi all,
We are planning to write a QNX device driver
for our PCI Express-to-SCSI/Serial ATA II adapter
device. Our PC platform is Intel Xeon E5620.
We are using QNX 6.5.0.
We have downloaded and checked the Generic x86 BIOS/APIC BSP.
But it doesn't contain any source code for devb-* components.
From QNX help, we found that devb-mvsata for
Marvell 88SX50XX SATA interfaces support
a device named 88SX6041 which is a
4-port SATA II PCI-X Controller. If we get the source code
for this driver as a reference, it will be helpful for us.
Could anyone tell me where can I get the source code of this
driver or could you please give any reference to existing driver
source codes which would be most similar to this device?
I couldn't find any documents regarding writing a block device
driver too anywhere.
Thanks in advance,
Warm Regards,
Lullaby
We are planning to write a QNX device driver
for our PCI Express-to-SCSI/Serial ATA II adapter
device. Our PC platform is Intel Xeon E5620.
We are using QNX 6.5.0.
We have downloaded and checked the Generic x86 BIOS/APIC BSP.
But it doesn't contain any source code for devb-* components.
From QNX help, we found that devb-mvsata for
Marvell 88SX50XX SATA interfaces support
a device named 88SX6041 which is a
4-port SATA II PCI-X Controller. If we get the source code
for this driver as a reference, it will be helpful for us.
Could anyone tell me where can I get the source code of this
driver or could you please give any reference to existing driver
source codes which would be most similar to this device?
I couldn't find any documents regarding writing a block device
driver too anywhere.

Thanks in advance,
Warm Regards,
Lullaby
- lullaby
- Active Member
- Posts: 82
- Joined: Fri Jun 15, 2012 6:19 am
Re: PCI express to SCSI/SATA2 driver
To obtain example source code, you should contact your QNX representative.
- maschoen
- QNX Master
- Posts: 2728
- Joined: Wed Jun 25, 2003 5:18 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests