View topic - mkifs with QNX6.4.1
mkifs with QNX6.4.1
6 posts
• Page 1 of 1
mkifs with QNX6.4.1
Hi,
So as the umpteenth method to try and get a bootable usb for my pc104 board, I am trying
http://www.qnx.com/support/knowledgebas ... 000000Smi2
when I type in mkifs bios.build bios.ifs
I get
Unable to open 'bios.ifs': No such file or directory
According to how the command works, this should be fine. Or can I not do this when I am running on a QNX CD?
Thanks.
So as the umpteenth method to try and get a bootable usb for my pc104 board, I am trying
http://www.qnx.com/support/knowledgebas ... 000000Smi2
when I type in mkifs bios.build bios.ifs
I get
Unable to open 'bios.ifs': No such file or directory
According to how the command works, this should be fine. Or can I not do this when I am running on a QNX CD?
Thanks.
- cciarleg
- Active Member
- Posts: 23
- Joined: Sat Jan 29, 2011 1:15 am
RE: mkifs with QNX6.4.1
it's mkifs bios.build >bios.ifs
- mario
- QNX Master
- Posts: 4132
- Joined: Sun Sep 01, 2002 1:04 am
RE: mkifs with QNX6.4.1
Mario,
You can run it like this:
# mkifs bios.build bios.ifs
at least for QNX 6.3.2 and QNX 6.5 you can.
You can run it like this:
# mkifs bios.build bios.ifs
at least for QNX 6.3.2 and QNX 6.5 you can.
- maschoen
- QNX Master
- Posts: 2728
- Joined: Wed Jun 25, 2003 5:18 pm
RE: mkifs with QNX6.4.1
Noted ok, funny though all my script file use the > .
- mario
- QNX Master
- Posts: 4132
- Joined: Sun Sep 01, 2002 1:04 am
Re: mkifs with QNX6.4.1
I'm having this same problem with or without '>', any ideas?
- abarber
- New Member
- Posts: 4
- Joined: Wed Oct 03, 2012 7:44 pm
Re: mkifs with QNX6.4.1
abarber wrote:I'm having this same problem with or without '>', any ideas?
Well if you are running from the CD, it won't work for the obvious reason. I think if you plug in a USB and it appears, say /fs/usb0, then you could redirect the output to that device
mkifs bios.build /fs/usb0/bios.ifs
- maschoen
- QNX Master
- Posts: 2728
- Joined: Wed Jun 25, 2003 5:18 pm
6 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests