View topic - Changing Resolution - QNX 4.23 with QNX Windows

Page 1 of 1

Changing Resolution - QNX 4.23 with QNX Windows

PostPosted: Mon Oct 12, 2009 10:47 pm
by Khab
Hey all,

Sorry, completely inexperienced with QNX so apologies if this is a stupid question. We have an older workstation running QNX 4.23 and QNX Windows, which runs a few legacy applications.

Anyone who previously did the support for the machine we have been unable to contact.

Recently we have found that, a couple of rarely-used forms do not fit on the screen - it is only running at 640x480 resolution.

From what I can tell, it is using gr.vga for the graphics driver, and it appears that 640x480 is the highest res mode I can see in this - would this be correct?

The video card is a generic, unlabelled, PCI card - can't even see anything written on the chipset etc to identify it.

What I am trying to determine, is how we can change the resolution to, say, 800x600.

I have tried browsing through the forums here, and searching for gr.vga, but pretty much everything I can see refers to Photon which, as far as I am aware, we do not have.

Is anyone able please to shed any light on this?

Cheers
Khab

RE: Changing Resolution - QNX 4.23 with QNX Windows

PostPosted: Tue Oct 13, 2009 3:34 pm
by maschoen
Yes there are drivers for higher resolution. Will they work with your generic card, ???? Can you swap out your generic card for something a little better ???

I think the driver for 800x600 is gr.svga although there are more specific ones. The support for Voodoo cards was pretty good and they are plentiful and cheap on eBay. I may be confusing Photon and QNX Windows support but at the end I think they were the same thing.