View topic - How to start code coverage using command line options?

How to start code coverage using command line options?

General Help about QNX

How to start code coverage using command line options?

Postby sunilkeshava » Fri Aug 28, 2009 9:42 am

Hi,

I have an executable built with code coverage enabled in it. If I launch this executable from the QNX IDE's code coverage perspective, then I can see that code coverage data is being collected in my target (i.e. there are few *.da files that get created).

However, if I run the executable using command line, then I dont see any *.da files being created. This should mean that the code coverage data is not being collected (correct me if I am wrong).

What are the command line options that I must provide to start code coverage?

Thanks
Sunil
sunilkeshava
New Member
 
Posts: 3
Joined: Thu Oct 16, 2008 12:58 pm

Return to Help

Who is online

Users browsing this forum: No registered users and 1 guest

cron