View topic - Initial crash

Initial crash

Read-only archive of qnx.newuser (Installation, configuration and administration of the QNX Neutrino or QNX Momentics environments) at

Initial crash

Postby Joseph Porter » Tue May 01, 2007 7:21 pm

I installed QNX on a generic Athlon-based HP PC. The installation looks
OK, but I immediately get a crash on boot:

Shutdown[0,0] S/C/F=10/2/6 C/D=f00151f9/f005d6e4 state(c0)= now lock
[0]PID-TID=1-5? P/T FL=00019001/04020000 "proc/boot/procnto-instr"
[0]ASPACE PID=77843 PF=00022010 "sbin/io-net"
x86 context[efff8808]:
0000: effaf00c f0058430 effb1f3c efff8828 effaf008 f0010df6

I'm assuming it's an incompatible hardware problem -- are there any clues
in this crash dump (hopefully transcribed correctly)?

Joseph Porter

RE: Initial crash

Postby joep » Wed May 16, 2007 4:13 pm

I should add that when I try "Run from CD", I get the following message:

No valid commercial license found
Only non-commercial use of this software is permitted.
Contact QNX Software Systems to acquire a development license.

Well I do have a license, but the process hangs at this point and never comes back.
New Member
Posts: 2
Joined: Wed May 16, 2007 4:07 pm

what has happened about crash no boot

Postby lawrephord3 » Sat Jul 21, 2007 12:44 am

what has happened about crash no boot :idea: any idea
New Member
Posts: 1
Joined: Sat Jul 21, 2007 12:15 am

Final resolution

Postby joep » Mon Jul 23, 2007 3:58 pm

I never posted the final resolution to my problem. It turns out that one of the PCI ethernet cards in my machine was causing the fault, so I took it took it out. Things seem to be working fine now.


For the curious, the offending card was:

a 3Com 3C905B-TX Fast Etherlink XL PCI that can do PXE boot. It's an old-ish PCI Ethernet card -- the ROM has a 1998 date on it.
New Member
Posts: 2
Joined: Wed May 16, 2007 4:07 pm

Return to qnx.newuser

Who is online

Users browsing this forum: No registered users and 2 guests