View topic - i.MX25 PDK/GPS driver for QNX

i.MX25 PDK/GPS driver for QNX

This is where you can ask a software to be ported or written for QNX. You can also request to buy/sell second hand software.

i.MX25 PDK/GPS driver for QNX

Postby nickynandanam » Mon Nov 28, 2011 10:00 am


I am planning to work on i.MX25 PDK. This development board has
support for GPS connector,OV 2640 camera, smart card etc. But the BSP
that I downloaded from QNX BSP directory doesn't contain drivers for
these modules. Can I get source code for these drivers? If not what are
the tools and documents available for developing driver programs?

Thank you,
New Member
Posts: 1
Joined: Tue Nov 01, 2011 12:46 pm

Re: i.MX25 PDK/GPS driver for QNX

Postby maschoen » Fri Dec 02, 2011 10:04 am

I can't say anything about whether the devices have existing drivers or not. If you can get source from another OS, you can try porting. Generally speaking a Linux or Unix driver is the best starting place.

In general, drivers for QNX are programs which are resource managers. The resource manager support library is really nice but takes a little getting used to. There are a few sources for drivers around that can be used as templates, for example the parallel port driver. The QNX documentation on this subject is not bad, but you have to read it carefully. I would recommend getting the paper version. There is also an independent book that has good material:

Getting Started with QNX Neutrino 2 -- A Guide for Realtime Programmers
QNX Master
Posts: 2682
Joined: Wed Jun 25, 2003 5:18 pm

Return to Request Software

Who is online

Users browsing this forum: No registered users and 1 guest