View topic - Create partition FAT in NAND

Page 2 of 2

Re: Create partition FAT in NAND

PostPosted: Tue Jun 07, 2016 12:52 pm
by cleitonbueno
Right. But you must have the devil-may driver for this, right? I tried to devf-generic but without success.
I can "mount" ETFS without this devf-? My case is a NAND Micron.

Re: Create partition FAT in NAND

PostPosted: Tue Jun 07, 2016 1:12 pm
by nico04
Usually, the devf driver sources needed for your board are in the BSP in src/hardware/flash.

Re: Create partition FAT in NAND

PostPosted: Tue Jun 07, 2016 4:12 pm
by cleitonbueno
Yes. But I'm using BSP I downloaded the QNX website does not. I will try to see some other than use this Micron memory.

Re: Create partition FAT in NAND

PostPosted: Tue Jun 14, 2016 10:25 pm
by cleitonbueno
Some example for dvd- driver for Micron Flash?
The BeagleBoard-xm uses Flash Micron, but devf- generates the error 'Bus Error' I have no knowledge with drivers for QNX.

Re: Create partition FAT in NAND

PostPosted: Wed Jun 15, 2016 6:58 am
by nico04

Re: Create partition FAT in NAND

PostPosted: Wed Jun 15, 2016 8:06 pm
by cleitonbueno
Thanks, I will download, check the flash and etfs in BSP, I go compile and test. Soon answer.