AAEON GENE-6310: Boot QNX (6.1 & 6.3)?

bridged with qnx.rtos
Post Reply
Jeff Maass

AAEON GENE-6310: Boot QNX (6.1 & 6.3)?

Post by Jeff Maass » Tue Jun 26, 2007 5:13 pm

Has anyone been able to boot the above-named SBC with
QNX 6.1 or QNX 6.3? Thespecific board is the 667 MHz
version, with VIA Eden processor.

These boards are PC-on-a-board types, with Phoenix-
AwardBIOS version 6.00PG.

Are there any BIOS settings that should be checked to
maximize the chance of booting from a new PC / board?

Jeff

Igor Mazanov

Re: AAEON GENE-6310: Boot QNX (6.1 & 6.3)?

Post by Igor Mazanov » Thu Jun 28, 2007 12:51 pm

Hello,

We run QNX Neutrino (6.3.0) successfully on AAEON AEC-6810 (GENE-6310 based)
Boxer fanless embedded controller. All things work, at least in QNX 6.3.0. It's
possible to boot this hardware from hard drive/CompactFlash, network, USB mass
storage device...

Regards,
Igor.

Jeff Maass wrote:
Has anyone been able to boot the above-named SBC with
QNX 6.1 or QNX 6.3? Thespecific board is the 667 MHz
version, with VIA Eden processor.

These boards are PC-on-a-board types, with Phoenix-
AwardBIOS version 6.00PG.

Are there any BIOS settings that should be checked to
maximize the chance of booting from a new PC / board?

Jeff

Post Reply

Return to “qnx.rtos”