Install of .qpr files

bridged with qdn.public.installation
Post Reply
Bob Miles

Install of .qpr files

Post by Bob Miles » Fri Aug 01, 2003 7:21 am

HI

We are using Momentics 6.2.1 - We read with interest someone elses struggles
with this at an earlier date !

We do not seem to be able to get "installer" from windows to even find some
proprietary (.qpr) software
we loaded on a user directory. - Basically we could not even navigate to it
!

We now run from terminal
qnxinstall our.qpr /CD-QNX*.

This presents us with the packages to install and we can "check" the boxes
against our desired packages but the INSTALL option does not become
available.

- What now ?

THANKS

Jerry Chappell

Re: Install of .qpr files

Post by Jerry Chappell » Fri Aug 01, 2003 2:24 pm

"Bob Miles" <rmiles@radamec.co.uk> wrote in message
news:bgd3j0$9bf$1@inn.qnx.com...
HI

We are using Momentics 6.2.1 - We read with interest someone elses
struggles
with this at an earlier date !

We do not seem to be able to get "installer" from windows to even find
some
proprietary (.qpr) software
we loaded on a user directory. - Basically we could not even navigate to
it
!
Can you provide some detail of the steps you took here?
We now run from terminal
qnxinstall our.qpr /CD-QNX*.

This presents us with the packages to install and we can "check" the boxes
against our desired packages but the INSTALL option does not become
available.
What is the state of the package in the right-most column? Check your system
clock to make sure that the date of the system is not set in the past,
before the package was released.

Jerry Chappell

Bob Miles

Re: Install of .qpr files

Post by Bob Miles » Fri Aug 01, 2003 2:56 pm

OK - we found the problem thanks

It looks as though we were NOT using 6.2.1 but 6.2.0 - is this a known
problem with 6.2.0.

With 6.2.1 properly installed everything is OK

Thanks again


"Jerry Chappell" <jchappell@qnx.com> wrote in message
news:bgdt8m$fq2$1@nntp.qnx.com...
"Bob Miles" <rmiles@radamec.co.uk> wrote in message
news:bgd3j0$9bf$1@inn.qnx.com...
HI

We are using Momentics 6.2.1 - We read with interest someone elses
struggles
with this at an earlier date !

We do not seem to be able to get "installer" from windows to even find
some
proprietary (.qpr) software
we loaded on a user directory. - Basically we could not even navigate to
it
!

Can you provide some detail of the steps you took here?

We now run from terminal
qnxinstall our.qpr /CD-QNX*.

This presents us with the packages to install and we can "check" the
boxes
against our desired packages but the INSTALL option does not become
available.

What is the state of the package in the right-most column? Check your
system
clock to make sure that the date of the system is not set in the past,
before the package was released.

Jerry Chappell

Post Reply

Return to “qdn.public.installation”